Jungle Smoke from T Spawn

Steps

1. In T Spawn, walk to the left wall and position yourself between the two wooden pallets on the ground. Stand so that you are centered between them, with your back against the wall.
2. Look up at the building ahead and find the balcony railing on the upper floor. There is a small gap between two of the railing posts.
3. Place your crosshair on the right edge of that gap - right where the second railing post begins.
4. Use your jump throw bind (hold left click, then press your jump throw key).
5. The smoke sails over the rooftops and lands in the jungle entrance, blocking all vision from jungle toward A ramp and palace.

Tips

• This smoke is one third of the classic 3-smoke A execute: jungle + stairs + CT. All three should be thrown simultaneously by different players for a coordinated site take.
• The jungle smoke specifically blocks CTs positioned in jungle from seeing players push through A ramp or exit palace.
• If the smoke lands too far forward (on the A ramp side), your crosshair was too low. If it lands too deep inside connector, you were aimed too far right.
• In a 5-stack, assign specific players to each smoke before the round starts. Calling “jungle, stairs, CT - throw on three” is the standard approach.
• You can also use this smoke independently in default rounds to deny information to the jungle player while your team works A ramp for a pick.

When to Use

This smoke is primarily used during organized A site executes. It is essential for:

• Full A executes with 3-4 players pushing through ramp and palace simultaneously
• A ramp pressure in default rounds to deny the jungle player sightlines
• Post-plant situations where you want to re-smoke jungle to prevent CT retakes from that angle
• Fake A setups where smoking jungle and stairs sells the idea of an A execute before rotating